![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
![]()
In fact, the VOR-A is almost perfectly lined up with runway 32;
In addition to the runway alignment issue, there are two other criteria used for issuing straight in minimums: descent gradients cannot exceed 400 ft/nm and the course must intersect the runway center line within a certain distance of the of the runway threshold, 3000-5200 ft in this instance. The descent gradients seem OK here, so my guess would be the point of course intersection was out of tolerance. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
High Price of Flying Wires? | PWK | Home Built | 34 | October 8th 17 08:24 PM |
Fwd: [BD4] Source of HIGH CHTs on O-320 and O-360 FOUND! | Bruce A. Frank | Home Built | 1 | July 4th 04 07:28 PM |
high impedance, low impedance? | JFLEISC | Home Built | 5 | April 11th 04 06:53 AM |
MT. DIABLO HIGH SCHOOL CONCORD, CA PHOTOS | MT. DIABLO HIGH SCHOOL PHOTOS | Home Built | 1 | October 13th 03 03:35 AM |
High performance homebuilt in the UK | NigelPocock | Home Built | 0 | August 18th 03 08:35 PM |