|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
December 18th 06, 01:52 AM
posted to rec.aviation.ifr
|
|||
|
|||
RNAV vectors
Stan Prevost wrote:
"Sam Spade" wrote in message ... The pilot can go to OBS mode and select FRZZN as the active waypoint, then select bearing 002 mag to FRZZN. You don't have to use OBS mode, at least on the GNS430. Use DIRECT TO, then set the course. This way draws a line on the map, OBS doesn't. That won't work with the GNS400/500 series. Doing it the way I describe will provide a course line. I don't have a clue about the 480. ;-) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Contact Approach -- WX reporting | [email protected] | Instrument Flight Rules | 64 | December 22nd 06 02:43 PM |
| RNAV Operations in FS2004 | Rookie | Instrument Flight Rules | 2 | November 30th 06 12:51 AM |
| RNAV approaches | Kevin Chandler | Instrument Flight Rules | 3 | September 18th 03 07:00 PM |
| RNAV approaches | Kevin Chandler | Piloting | 3 | September 18th 03 07:00 PM |
| Slam dunk into Janesville | Steven P. McNicoll | Piloting | 0 | July 31st 03 02:08 AM |
Threaded Mode