![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#8
|
|||
|
|||
![]()
John Scott wrote:
My glider has a dipole antenna built into the rear edge of the rudder. How do I tune the VSWR for this antenna. Cutting a chunk off is not possible. John Rear edge? Odd, most gliders have them in the leading edge of the vertical stabilizer. Anyway, the bottom line is that you cannot change the length of the antenna. We are all [retty much in the same boat. It would be great if we could retune the antenna (change the length) for 123.3 (or whatever frequency you use). This would optimize our power out. However, this is not practical so we live with antennas that are probably optimized only for the middle of the 118.000 - 136.975Mhz range. What is the middle? 127.4875Mhz. This is at least pretty close to where we usually transmit. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
I Hate Radios | Ron Wanttaja | Home Built | 9 | June 6th 05 05:39 PM |
LORAN antenna difference? | JFLEISC | Home Built | 6 | December 24th 04 10:10 PM |
Antenna ground plane and coax grounding | G. Fred McCutchen | Home Built | 2 | August 8th 04 12:27 PM |
ELT antenna -- Pitts | Al MacDonald | Home Built | 0 | July 15th 04 03:27 PM |
Yaesu/Vertex coax antenna adaptor | RM | Piloting | 15 | July 13th 04 09:32 PM |