|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 22nd 07, 12:58 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
recorcinal glue: catylst and timing
I did some gluing yesterday at 70* and could have used just a bit more
time before clamping the pieces. Can I gain more time by reducing the amount of catalyst? Can I gain more time by glueing at a cooler point in the day? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bad timing... | Jay Honeck | Piloting | 39 | March 13th 07 08:19 PM |
| Bad timing... | Jay Honeck | Owning | 36 | March 13th 07 08:19 PM |
| timing holds | [email protected] | Instrument Flight Rules | 16 | February 17th 05 12:18 AM |
| Approach Timing | john smith | Instrument Flight Rules | 36 | September 9th 04 03:37 PM |
| Timing on Subaru EJ22 ??? | Randy | Rotorcraft | 1 | November 9th 03 06:15 AM |
Threaded Mode