|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
September 25th 07, 03:49 PM
posted to rec.aviation.owning
|
|||
|
|||
Voltage, EDM-700, trim switch follow-up
Jay Honeck wrote:
Today, we're installing the JPI outside air temperature probe that I purchased last May. We're gonna install it like Jack Allison did, Once that's installed, I'm planning to remove the ugly through-the- windshield temperature probe. I could be wrong, but I don't think the JPI OAT probe is STCed as a replacement for the factory-though-the-windshield probe. -- Frank Stutzman Bonanza N494B "Hula Girl" Boise, ID 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Voltage variation | Jay Honeck | Owning | 18 | October 3rd 07 09:05 PM |
| Electric trim switch -- source? | Jay Honeck | Owning | 19 | August 1st 07 02:06 AM |
| Mooney Low Voltage | [email protected] | Owning | 22 | August 1st 05 01:01 PM |
| FA: 12V to 24V DC voltage converter | Karl Geng, N1DL | Home Built | 2 | April 21st 05 08:48 PM |
| Remote Switch for Pointer ELT --- Why Does It Need Voltage? | jls | Home Built | 1 | November 22nd 04 09:13 PM |
Threaded Mode