![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I have owned this Cherokee 140 since 1994. I have logged over 1000 hours
in it through the original and the now installed overhauled engine. Oil temps were usually at 180 degrees (both engines)when OATs were between 50-80 degrees or so. It would read 1 needle mark higher when it got to be 95+ outside. In the last 150 hours or so, it has been drifting up and is now reading about 2 needle marks above 180 degrees (200 degrees or so?). I replaced the oil cooler because of age. It was cheaper to replace it with a new PMA'd unit than to have it checked/cleaned. I swapped the Vernatherm. No difference. Do the gauges/senders drift off with age. I am going to test the sender/gauge with hot water and a thermometer. Once it gets to that mark, it seems to stabilize. Baffles are all in good shape. What else causes temps to drift high? I know that shifting main bearings can cause this, but I doubt the engine would continue to operate for this long if this were the case. I do wonder though because the cold oil pressure is right at redline on takeoff. After 5 minutes it goes back down into the middle of the green. Thoughts/theories? Thanks, Mike |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
C182 Oil Temp | Steve Leonard | Soaring | 1 | October 8th 07 10:33 PM |
carburator temp sensor | Philippe Vessaire | Home Built | 0 | May 14th 06 04:35 PM |
Cessna 172 Oil Temp | Darrel Toepfer | Owning | 10 | June 26th 05 04:04 PM |
c-182 carb temp gauge | R.T. | Owning | 1 | November 23rd 04 10:48 PM |
carb temp probe | Philippe Vessaire | Home Built | 1 | September 20th 03 08:21 AM |