|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 2nd 10, 02:03 PM
posted to rec.aviation.ifr
|
|||
|
|||
Weird Indications on Aspen EFD1000/Garmin 430W
I was flying the ILS 06 approach on my plane equipt with an Aspen and
Garmin 430. I had the Garmin set up for vectors to final, tuned properly, set on VLOC, station identified and was flying near the OM towards the FAF. Then I noticed the Aspen said "BC1", was reverse sensing, and showing no vertical navigation guidance. My other VOR (standard VOR) was tracking correctly. There is no runway 1 at MJX, just 6/24. I have no idea why this happened. Any ideas ? Possibly I did not have the course set correctly on the Aspen. Would that cause this to happen ? Auto-course select may have been turned off. Thanks. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Non-published hold with Garmin 430W | Evan Salant | Instrument Flight Rules | 1 | November 25th 09 03:09 PM |
| Aspen EFD1000 | [email protected] | Instrument Flight Rules | 0 | October 26th 08 07:39 AM |
| Aspen EFD1000 | [email protected] | Instrument Flight Rules | 0 | October 25th 08 04:43 PM |
| Garmin 430W autopilot operation | Glasair470 | Instrument Flight Rules | 7 | January 17th 08 12:37 PM |
| Garmin 430W holding help? | Paul kgyy | Piloting | 1 | April 10th 07 11:36 PM |
Threaded Mode