![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#16
|
|||
|
|||
![]()
On Aug 16, 2:53*pm, a wrote:
On Aug 14, 6:56*pm, "Flaps_50!" wrote: On Aug 12, 1:42*pm, a wrote: The good news is, it's rare to the best of my knowledge that moving the controls to the extremes,. either fast or slow, will uncover a problem, or that they fail in flight. Err, I don't think you mean that. Cheers I have not done much research on the matter but can not recall a control surface failure or linkage to a control surface of the sort that might be be uncovered during run up as leading to an in flight failure. One can fly a GA airplane into extreme turbulence and have structural damage, but that possibility would not be uncovered in a run up either. So yes, I did mean what I typed. If there are factual examples of in flight failures of control linkages that might have been uncovered during run up I'd be happy to learn of them. Ok, but that's not what you wrote. Cheers |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
To blow or not to blow... | Dallas | Piloting | 50 | February 15th 08 12:57 PM |
Another blow for Airbus | AJ | Piloting | 1 | December 9th 06 08:35 PM |
oil blow out IO-360 | Robert M. Gary | Piloting | 18 | July 17th 06 04:44 PM |
oil blow out IO-360 | Robert M. Gary | Owning | 18 | July 17th 06 04:44 PM |
Blow-Proofs | jls | Home Built | 0 | June 2nd 04 05:02 AM |