|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
July 16th 12, 07:42 PM
posted to rec.aviation.soaring
|
|||
|
|||
Trailer Ramp Jack - NO SCREWS - follow up
On Jul 13, 7:57*pm, wrote:
On Thursday, June 18, 2009 12:35:41 AM UTC-4, Tim Taylor wrote: To follow up on Uncle Fuzzy's design I modified therampon my Pfiefer tube trailer from the early 80's. Images at: http://picasaweb.google.com/TTaylor07/TrailerJack I used four wheels rather than two for a little more surface area. *On real soft ground you could carry two 12"x12" *pieces of plywood if needed. Hi One *good solution used on a jantar is a jack to lift a motorcycle. Best after market solution! S6 1. Too heavy 2. Too bulky 3. Thrust bearings tend to break So no it is not the best after market solution. Been there, tried that. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra trailer hydraulic jack refurb? | Frank[_1_] | Soaring | 5 | March 12th 09 11:50 PM |
| Komet Trailer Ramp Jack - NO SCREWS | [email protected] | Soaring | 7 | April 23rd 08 05:39 AM |
| Ramp jack for Komet Trailer | [email protected] | Soaring | 8 | April 2nd 08 05:37 PM |
| Double scissor jack for trailer ramp? | Bullwinkle | Soaring | 15 | January 18th 06 05:18 PM |
| Aluminum Extrusion for trailer ramp (USA) | ttaylor at cc.usu.edu | Soaring | 5 | June 28th 05 04:19 PM |
Threaded Mode