|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 23rd 13, 02:11 PM
posted to rec.aviation.soaring
|
|||
|
|||
Need a tie-down sleeve (cuff?) for LS-4
.... and actually a couple other gliders too. I would like to get the ball rolling on this, but don't know where to sart. MM or Fidel come do mind. If needed*, I could provide a 'section' *have otwire, CFPRO, and cnc template capability) (and ordinate files) , but I'll bet that's stupid amounts of overkill.
The tie-down sleeve for the LS4 would be the priority, followed by the Janus, and then a tow-out wing wheel setup for the Speed Astir) Thanks, Jim * Maybe. Last year - easy - now? I'm not sure, though I've cut literally hundreds of cores. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fiberglass Wing Cuff | vontresc | Soaring | 11 | May 14th 10 05:19 AM |
| Shrinking inner sleeve | Michael Horowitz | Home Built | 1 | August 12th 08 09:44 AM |
| Any tricks to forming an inner sleeve? | Michael Horowitz | Owning | 0 | September 7th 07 11:05 PM |
| Tie down sleeve for Ventus 2 | Steve Leonard | Soaring | 7 | April 5th 07 09:04 PM |
| Navman GPS sleeve | Oscar Goudriaan | Soaring | 1 | March 2nd 07 10:27 PM |
Threaded Mode