|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 23rd 16, 11:42 PM
posted to rec.aviation.soaring
|
|||
|
|||
Reducing PPG Concept Urethane
I shot my first batch of PPG concept today, and it shot slower (and had more orange peel) than I expected. When I was shooting the primer, I accidentally over reduced it - and discovered that it sprayed much better. Smoother finish and faster spray.
I mixed the PPG per the instructions: 4 paint, 2 reducer, 1 hardener. I'm wondering if "over reducing" will make it spray better. And also what are the risks of using too much reducer. I know it may run, but is there anything other than runs that I should be watching for? Thanks, John 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Urethane Paint | Jonathan St. Cloud | Soaring | 44 | November 20th 15 10:48 AM |
| urethane 2K paint | [email protected] | Soaring | 1 | February 4th 14 11:30 PM |
| Reducing canopy glare caused by instrument face reflections. | [email protected] | Soaring | 1 | November 11th 13 09:22 PM |
| Reducing Fuel use and Increasing your car speed with FFI MPG-CAPS | sexy girl | Piloting | 0 | February 23rd 08 05:47 AM |
| Reducing the Accident Rate | Snowbird | Piloting | 92 | July 22nd 04 01:31 PM |
Threaded Mode