|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
June 24th 17, 05:51 PM
posted to rec.aviation.soaring
|
|||
|
|||
1987 Cobra Trailer Brake drum removal
On Saturday, June 24, 2017 at 11:30:39 AM UTC-4, wrote:
Bolt appears welded to axle arm. Cannot remove spindle either. I've worked on a number of these over the years, so I can't remember exactly which version is which. But, I would start with finding part numbers and hitting Google. There are a number of catalogs available online that show the components and in some cases very nice service instructions. It sounds like your version may be one of the earlier ones where the brake backing is integral to the spindle. It may not in fact be possible to remove. Of course, Spindleberger is probably the best bet... P3 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra trailer brake heating up | Eric Greenwell[_4_] | Soaring | 14 | August 14th 18 05:48 AM |
| Brake Drum needed for a 1984 Cobra | Nick Kennedy | Soaring | 4 | June 27th 15 03:29 AM |
| FS Cobra brake drum w/new bearing | Hartley Falbaum[_2_] | Soaring | 1 | December 3rd 11 01:05 PM |
| Source for Cobra Trailer Brake Shoes | Chip Bearden[_2_] | Soaring | 1 | September 22nd 10 02:48 AM |
| Older Cobra trailer brake oscillation | Brian Bange[_2_] | Soaring | 9 | March 10th 09 07:41 PM |
Threaded Mode