![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
Europe went to a smaller freq spacing a few years ago....thus, many EU radios are "junk" since they can't handle the freq spacing.
For at least the US, they are perfectly fine and likely way better than older US radios.... Sooooo........newer radio that matches US/FCC rules but not EU rules. At least, my understanding. Research before buying, but I believe I am correct. |
#12
|
|||
|
|||
![]()
On Wednesday, July 17, 2019 at 7:14:12 AM UTC-7, wrote:
Curious, why is it a better radio ? Dan The digital encoder on the FSG2T doesn't work well if dirty, like digital encoders on other equipment. It's easy to clean. I recommend the same stuff as in the CAI303 thread: https://caig.com/product/deoxit-d5s-6/ Remove the radio, remove the dual concentric knobs, undo 4 screws, remove the face, squirt, replace everything. Besides being easier to set up microphones and having variable squelch, the FSG2T deals with noise from USB stuff much better than the FSG71M. Perhaps the 71M predated USB stuff in the cockpit? Jim |
#13
|
|||
|
|||
![]()
On Thursday, 18 July 2019 02:14:12 UTC+12, wrote:
Curious, why is it a better radio ? Dan On Wednesday, July 17, 2019 at 2:35:50 AM UTC-4, wrote: I bought a 2T from Ross. If you have an FSG-71, it is a direct replacement and is a much better radio. I replaced my 71 with a 2T from Ross and the fidelity was much better. As Roy says, the channel selector switch can be a weak point though. I understand it is more susceptible to external mechanical impacts. |
#14
|
|||
|
|||
![]()
Only 5 left.
|
#15
|
|||
|
|||
![]()
On Tuesday, July 23, 2019 at 12:59:17 PM UTC-7, Ross wrote:
Only 5 left. I am interested in 2 radios for my club. Please contact me.... -mike |
#16
|
|||
|
|||
![]()
I still have a couple of these if anyone is interested
|
#17
|
|||
|
|||
![]()
On Friday, November 8, 2019 at 2:41:19 AM UTC-5, Ross wrote:
I still have a couple of these if anyone is interested Hello Ross, do you have any left? I am interested in one. Thanks, Joe |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
F.S. Dittel FSG2T Set | Ross[_3_] | Soaring | 1 | March 1st 16 05:42 AM |
FS: Dittel FSG2T | Ross[_3_] | Soaring | 2 | February 1st 16 06:32 AM |
FS: Dittel FSG2T | Romeozulu | Soaring | 0 | March 31st 15 08:48 AM |
Turnaround time for Dittel FSG2T Radios | Charlie Papa | Soaring | 3 | December 1st 10 11:10 PM |
Service Bulletin on Dittel FSG2T Radios | Paul Remde | Soaring | 0 | September 9th 10 05:31 PM |