|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 7th 04, 01:57 PM
|
|||
|
|||
The typical sequence at a large airport is:
1) listen to ATIS frequency... note pertinent info. 2) contact clearance delivery with ATIS code... get clearance and Departure freq. 3) contact ground get taxi clearance 4) contact tower when ready to go for TO clearance 5) on climbout tower has you contact departure in freq assigned by (2) 6) departure hands you off to center (if IFR or sometimes VFR with FF) This sequence would be the same for all aircraft departing. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GPT (Gulfport MS) ILS 14 question | A Lieberman | Instrument Flight Rules | 18 | January 30th 05 04:51 PM |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 05:03 AM |
| Phoenix AIM-54A (QUESTION) | Krztalizer | Naval Aviation | 10 | February 23rd 04 07:22 AM |
| Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 01:26 AM |
Hybrid Mode
