|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 8th 04, 10:53 AM
|
|||
|
|||
"tony roberts" wrote in message
news:nospam-298825.23052207092004@shawnews... TCP themselves, and many knowledgeable sources, all say that you should never use TCP in a higher than 1000 TBO engine. NTSB reports site TCP (and MMO) as causes of accidents in high time engines, where crap has been dissolved/dislodged TBO or SMOH? What about if you've been using it from the start? Paul 
|
|
#2
September 9th 04, 03:27 AM
|
|||
|
|||
|
TBO or SMOH? What about if you've been using it from the start? At 1000 hours they are both about the same  The advice I got was not to START using it on a mid to hightime engine, because of existing buildups which can dislodge. If they have been used from the start, and performed as advertised there shouldn't be any buildups. But personally I would ask the manufacturer first. Tony -- Tony Roberts PP-ASEL VFR OTT Night Cessna 172H C-GICE
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Decalin instead of TCP? | Bob Fry | Home Built | 9 | September 14th 04 05:21 AM |
Hybrid Mode
