|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 22nd 03, 12:33 AM
|
|||
|
|||
What are your suggestion to close this gap? I am tempted to get some
insulation from the local hardware store and fix it, but my AP will frown on that. Any suggestions? If it's small, a dot (or line) of clear silicone caulk will do the trick. -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turnabout by SEAL Authentication Team | Fred the Red Shirt | Military Aviation | 1 | August 22nd 04 06:43 PM |
| Remove oil seal from vacuum pump adapter on Lycoming IO320 HOW????? | Ron | Home Built | 2 | February 24th 04 04:34 PM |
| Weatherstripping | Hankal | Owning | 3 | November 29th 03 01:09 AM |
| Crank Seal? | Mark S Conway | Owning | 3 | November 10th 03 04:29 AM |
| FS: Piper Side Window (New) | JimC | Aviation Marketplace | 0 | August 10th 03 12:19 PM |
Hybrid Mode
