|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 4th 04, 02:41 PM
|
|||
|
|||
Well ok, but I like a bench I can bolt a vise to and beat the crap out of whatever is clamped in it without the bench changing
hangers. Sounds more like you just need one of those stainless work tables from Sam's Club. (or are they just chrome?) Or....hmmm, everything synthetic I can think of costs too much. Mike "Jim Weir" wrote in message ... Oooookay, let me try again. What NONLUMBER bench tops have you ever seen or considered that might work? I'm not making 747s, fellers, nor am I building spars. The worst I might want to do is bend up a 4" x 6" bracket out of 5052H32 and drill it with a Harbor Freight benchtop drill press. Jim 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Benchtops & Shelving | Jim Weir | Home Built | 30 | March 6th 04 01:32 PM |
Hybrid Mode
