![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Bernie the Bunion wrote in message ...
jls wrote: In about 15 minutes here came a little man in a truck with the jug, which had left a crater in his front yard. Some years ago up here in Edmonton a wheel came off a DC-6 ( I believe ) and went through someone's roof. The owner of the house or apartment had just gone into the kitchen to make a snack when kaboom.... right into the living room. To the locals ---- correct me if I am wrong. Didn't that happen in New York, too, many years ago? A dual-wheel and tire assembly, I think it was, that landed in a downtown street. Didn't kill anyone, as I remember. But my memory isn't that good. Anyone else remember? Dan |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
0200A Higher Compression Cylinders? | Boelkowj | Home Built | 3 | December 16th 03 02:25 PM |
0-320 cylinders | Drew Dalgleish | Home Built | 9 | December 8th 03 04:25 PM |
0-235 lyc cylinders needed (3) | Captain Dave | Home Built | 0 | October 8th 03 08:00 PM |
what's a good country for a homebuilt aircraft? | Lukas | Home Built | 17 | September 25th 03 06:53 PM |
bulding a kitplane maybe Van's RV9A --- a good idea ????? | Flightdeck | Home Built | 10 | September 9th 03 07:20 PM |