![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Bob
Get a heat gun and deactivate the heating element. Put a 12/24 VDC motor on to replace the 110 VAC one. Use blower to turbo your leaf blower. Just think out of the box. Big John Point of the sword On 10 Jul 2003 15:30:28 GMT, osit (RobertR237) wrote: In article , "Model Flyer" writes: Bob, the simple answer is, the leaf blower is turbo charged.:-) -- . -- Cheers, Jonathan Lowe modelflyer at antispam dot net Damn, why didn't I think of that? Now where can I buy one of those turbo charged leaf blowers? I am tired of climbing on top of my high pitched roof to blow pine needles and one of those should do the trick in short order. Bob Reed www.kisbuild.r-a-reed-assoc.com (KIS Builders Site) KIS Cruiser in progress...Slow but steady progress.... "Ladies and Gentlemen, take my advice, pull down your pants and Slide on the Ice!" (M.A.S.H. Sidney Freedman) |
#2
|
|||
|
|||
![]()
In article , Big John
writes: Bob Get a heat gun and deactivate the heating element. Put a 12/24 VDC motor on to replace the 110 VAC one. Use blower to turbo your leaf blower. Just think out of the box. Big John Point of the sword Ah hell, can I just hire a 16 year old kid and have him do it? Bob Reed www.kisbuild.r-a-reed-assoc.com (KIS Builders Site) KIS Cruiser in progress...Slow but steady progress.... "Ladies and Gentlemen, take my advice, pull down your pants and Slide on the Ice!" (M.A.S.H. Sidney Freedman) |
#3
|
|||
|
|||
![]() "Big John" wrote in message ... Bob Get a heat gun and deactivate the heating element. Put a 12/24 VDC motor on to replace the 110 VAC one. Use blower to turbo your leaf blower. Just think out of the box. Some of the hair driers use a 12volt motor in series with the heater, if he used one of those all he would have to do is remove the element and connect directely to the bat. -- .. -- Cheers, Jonathan Lowe modelflyer at antispam dot net Antispam trap in place Big John Point of the sword On 10 Jul 2003 15:30:28 GMT, osit (RobertR237) wrote: In article , "Model Flyer" writes: Bob, the simple answer is, the leaf blower is turbo charged.:-) -- . -- Cheers, Jonathan Lowe modelflyer at antispam dot net Damn, why didn't I think of that? Now where can I buy one of those turbo charged leaf blowers? I am tired of climbing on top of my high pitched roof to blow pine needles and one of those should do the trick in short order. Bob Reed www.kisbuild.r-a-reed-assoc.com (KIS Builders Site) KIS Cruiser in progress...Slow but steady progress.... "Ladies and Gentlemen, take my advice, pull down your pants and Slide on the Ice!" (M.A.S.H. Sidney Freedman) |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Aerobatics | 28 | January 2nd 09 02:26 PM |