|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
February 2nd 04, 06:22 PM
|
|||
|
|||
In article ,
" jls" wrote: "Richard Riley" wrote in message ... I've just finished machining my instrument panel. It is (I say with no small pride) nice. Milled out of 2024T3 3" thick, reduced to .120 with .120 webs between each instrument and around the perimeter. Now the question is: how should it be finished? Polished? Engine turned? Anodized? Clear powder coat? Alodine it and then put up a frilly little placard that says 24K. It would be reminiscent of you. If you first polish it, then dip it in alodyne, it will look like a piece of gold jewelry. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
| CAD outline of Rans S6S instrument panel? | Rob Turk | Home Built | 2 | October 21st 03 09:27 PM |
Hybrid Mode
