|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
May 13th 04, 02:55 AM
|
|||
|
|||
"Scott G." wrote in message ...
Does anyone have any information whether Aerospace Logic's Fuel Gauge is a primary gauge replacement, or if the original fuel gauge would still need to be kept in the airplane? Application would be a Cessna 206. Scott, Can't be specific about the 206, but my ramp neighbor recently replaced all of his OEM gauges with the Aerospace Logic gauges under the STC. His old Piper OEM gauges were removed, so I would assume that the STC allows for direct replacement. This was on a PA-28 John Galban=====N4BQ (PA28-180) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cessna 172 with Wild Fuel Gauge Needle | jls | Owning | 26 | February 20th 04 05:56 AM |
| Airplane Parts on Ebay Vac Reg Valves, Fuel Floats, O-200 Spider, Fuel Injection Valve | Bill Berle | Home Built | 0 | January 26th 04 07:48 AM |
| Airplane Parts on Ebay Vac Reg Valves, Fuel Floats, O-200 Spider, Fuel Injection Valve | Bill Berle | Owning | 0 | January 26th 04 07:48 AM |
| Jim Weir's Capacitive Fuel Gauge | Dave Bowman | Home Built | 0 | January 22nd 04 03:06 AM |
| Yo! Fuel Tank! | Veeduber | Home Built | 15 | October 25th 03 02:57 AM |
Threaded Mode