![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Tony,
The chemical solutions are the better way to go. If they do not work 600 paper will scratch the living daylights out of the windshield. Sounds like they are trying to sell more products. If you use "sand" (abrasive) paper then start with 2000 and move up to 4000 or 6000 if you can get it. Michelle tony roberts wrote: so - the continuing saga - after my glareshield fell off on takeoff (see earlier post) a friend repaired it and remounted it. Then he noticed that he had "missed" a few spots so he brought the aerosol of black paint into the cockpit . . . well, you can guess the rest. Does anyone know how to remove black paint spots from the windshield? 600 grade wet and dry paper was suggested by our local aircraft parts supply house - sounds a bit extreme to me. I also tried lexan scratch remover - GREAT product - available from any good Harley Dealer - great on scratches that is - not too hot on paint. Any ideas gratefully received Tony -- Michelle P ATP-ASEL, CP-AMEL, and AMT-A&P "Elisabeth" a Maule M-7-235B (no two are alike) Volunteer Pilot, Angel Flight Mid-Atlantic Volunteer Builder, Habitat for Humanity |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
One coat paint for aluminum? | [email protected] | Home Built | 10 | September 17th 04 07:01 AM |
Arrgh! I may have scratched my windshield! | Peter R. | Owning | 7 | April 28th 04 07:58 AM |
paint shop recommendations wanted (SE) | Stephen N Mills | Owning | 0 | January 29th 04 03:44 PM |
Radar Absorbing Paint | robert arndt | Military Aviation | 2 | December 2nd 03 05:09 PM |
Choice of Paint for use over Copper foil Antennas | Charlie Precourt | Home Built | 1 | December 2nd 03 02:51 AM |