|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 21st 04, 01:01 AM
|
|||
|
|||
JFLEISC wrote:
/snip/ Any ideas? What is staring me right in the face that I missed? Jim "boy I like my Lycoming" F Jim, it's a long shot, but are the plug wires routed correctly? As you know, on that engine, one mag runs all the tops, and the other all the bottoms. Maybe someone installed them in the more conventional, staggared arrangement? Just SWAG... Happy Flying! Scott Skylane N 92054 
|
|
#2
June 21st 04, 02:20 AM
|
|||
|
|||
|
it's a long shot, but are the plug wires routed correctly? As you know, on that engine, one mag runs all the tops, and the other all the bottoms. Maybe someone installed them in the more conventional, staggared arrangement? Just SWAG... Happy Flying! Scott Skylane N 92054 I should have mentioned that I did confirm this. I should note that everything "wire wise" is the same. I replaced only the right mag but not the wires. That bad mag, of course, would hardly run correctly for a minute at a time. Jim
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| YAMAHA FZ 750 FZ750 RUNNING GENESIS ENGINE FOR SALE | Karsten | Home Built | 0 | September 3rd 04 07:34 PM |
| Rotax 503 won't stop running | Tracy | Home Built | 2 | March 28th 04 04:56 PM |
| PIREP: 2I3 (Rough River State Park, Falls of Rough, KY) | Kyler Laird | General Aviation | 0 | March 1st 04 12:11 AM |
| Rough Engine, please help | John Clonts | Owning | 14 | February 26th 04 12:09 AM |
| rough engine just after power reduction | Sydney Hoeltzli | Owning | 11 | July 30th 03 03:37 PM |
Hybrid Mode
