![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
A visual inspection of the alternator showed that the windings on the
rotor were black and shedding burned insulation. An ohmmeter showed less than one ohm field resistance. The stator windings looked good and tested good as did the diodes. John On Sun, 14 Nov 2004 08:28:00 GMT, Economic Girly Man wrote: John_F wrote: Cold weather, a hard to start engine and a old tired 60 amp alternator breaker that was later found to trip at 35 amps cost me a new voltage regulator, a new alternator, a new breaker, and a new over voltage lamp when the breaker popped one cold night just after take off. The OV light did not last long when fed 90 volts and was like a red flash bulb. (What was that flash??) By the time I went around the pattern to land the regulator and alternator field was also fried. On a My deepest sympathies. How did you determine that you *fried* the alternator field? How exactly did it fail (open, shorted ???) Any failures on the stator side (diodes ???) EGM |
Thread Tools | |
Display Modes | |
|
|