|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 12th 04, 02:04 PM
|
|||
|
|||
Guys,
thanks for all your help. I purchased a DMC crimp set last night. Actually, I think it was the one a link was provided. I also managed to find a good Molex pin crimper. Thanks for all the help! Michelle Michelle P wrote: I am looking for an in-expensive pin crimper for d-type and Cannon Plug style pins. The range for wire size needs to be at least 24 to 18 Gauge. The ones I am currently looking at are DMC/Daniels mil-spec (like the ones we have at work) and are running in the $500 range. Un-fortunately I cannot borrow the ones we have a work. Any help would be appreciated. Michelle 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Inexpensive wiring conduit idea | [email protected] | Home Built | 13 | September 1st 04 08:22 AM |
| need inexpensive manuals for 172 | Mike Z. | Owning | 4 | October 30th 03 12:10 AM |
| Inexpensive Part 135? | Brien K. Meehan | Owning | 2 | July 2nd 03 03:30 AM |
Hybrid Mode
