![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Chris Wertman wrote:
Hello all This is for a non-avaition project Now don't be keeping us in suspense........ Whatcha building. |
#2
|
|||
|
|||
![]()
Now don't be keeping us in suspense........
Whatcha building. A motorcycle ![]() chopper frame that has a C shaped engine basket theat is more than big enough to nestle in the Lawrance radial, 5 exhaust pipes and the sound of a radial is just too tempting for me not to try. And its a little more sane than my pitbike that had a honda 350 on a JR50 frame ![]() Chris |
#3
|
|||
|
|||
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help ! SMALL Radial engine | Chris Wertman | Home Built | 12 | July 18th 05 02:46 PM |
Cylinder Wrenches for 0-320A Narrow Deck | DAVE | Home Built | 1 | December 31st 03 01:45 PM |