|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 1st 04, 06:15 PM
|
|||
|
|||
"Morgans" wrote in message
Perhaps I missed it. Where are the pictures? http://groups.yahoo.com/group/Fly5kf...SIC%20BENDING/ Or http://25th.com/t2/viewfull.php?index=621 http://25th.com/t2/viewfull.php?index=622 http://25th.com/t2/viewfull.php?index=623 http://25th.com/t2/viewfull.php?index=624 For a brake I built with Veeduber's inspiration. This is an 8 ft'r. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sheet metal shear/press brake | VideoFlyer | Home Built | 7 | October 7th 03 07:08 PM |
| ?s about building a gyrocopter | John Normile | Home Built | 2 | September 14th 03 02:01 AM |
| Brake caliper flange | Stealth Pilot | Home Built | 5 | July 7th 03 04:19 PM |
| Brake line design question | Charlie Smith | Home Built | 0 | July 2nd 03 12:31 PM |
Hybrid Mode
