![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Wed, 14 Apr 2004 08:50:59 -0500, "L.D."
wrote: wrote: On Tue, 13 Apr 2004 15:47:18 -0500, "L.D." wrote: Orval Fairbairn wrote: In article . net, UltraJohn wrote: I double checked and it was Exxon and it is quite pricey. . . regular 93 octane here is about 195 and this 110 leaded was 4.25 a gallon! but hey if your running 12.5 to 13.0 to 1 compression you have to pay the price. .;-) John Actually, you can get an extra boost if you mix 1:4 ratio 100LL and premium unleaded. Low concentrations of TEL yield large octane boosting. Orval, When you say "extra boost", what do you mean? If you mean power, you are wrong. Higher octane is less explosive, harder to set off, less power, that is the reason you don't get preignition. It won't ignite from high compression, a glowing piece of carbon or early timing, etc as lower octane will. To get the most power use the lowest octane you can with out ignition knock. L.D. No, better to tune the engine to make use of the extra octane. Higher CR, more advance, or better intake/exhaust can allow the engine to use the extra octane and produce significantly higher power. High octane fuel does not necessarily burn slower, it is just less prone to auto-ignition. Propane burns faster than gasoline and is 150 octane, on average. I have had several vehicles over the years that produced enough extra power (and therefore economy) on hightest to MORE than pay the difference in cost. Being computer controlled engines, knock was never an issue - I could likely have run the thing on Kerosene after it was warmed up. Oh yes, I agree to tune the engine, higher cr, more advance and so on, but that aggravates pre ignition. Then you may have to use higher octane. I didn't mean to use lower octane instead of good tune. When you do tune correctly and you still don't have pre ignition, then no need to use higher octane. In fact it is counter productive. You said propane has about 150 octane. I new it was very high although I didn't know the exact #. That is my point, I have run propane in trucks and tractors and it doesn't have as much power and it uses more fuel. So again my belief is octane rating is not a power rating. If it was, burning propane would give more power. L.D. You are missing the point. An engine TUNED for high octane fuel will produce more power from each gallon of that high octane gas, still below the "detonation" point, than an engine properly tuned for low octane will on low octane. It is also obvious you have never converted IC engines for propane in a serious way. Propane has a lower energy content per lb than gasoline, but if properly set up to take advantage of the octane available in propane, the engine WILL produce significantly more power than the original engine running on gasoline. Proper conversion of a carbureted engine required cold manifolding, different plugs, modified timing, among other things. You WILL use more fuel. Octane is NOT a power rating, but high octain fuel, while not CAUSING an engine to produce more power, definitely ALLOWS it to. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hot weather and autogas? | Rich S. | Home Built | 33 | July 30th 03 11:25 PM |