![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
"Julian Scarfe" writes:
In case of failure of the hydraulic system 1. move the gear selector lever to "down" 2. actuate the emergency gear extension system (AFAIR that releases something and the gear drops under gravity) "Kyler Laird" wrote in message ... "actuate" here means "reach under the left seat, flip up the door, and yank the ring(?)". It causes CO2 to be released from a small tank into the hydraulic system, making a mess and eliminating further worries about what to do with the gear or flaps. Gravity plays a minor role. That's the one. It did sound like a desperation measure. Julian |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |
Wanted clever PA32 engineer's thoughts - Gear extention problem on Piper Lance | [email protected] | Owning | 5 | July 22nd 03 12:35 AM |