|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 27th 04, 10:47 PM
|
|||
|
|||
Dave S wrote:
Buy a dynon.. 1800 bux and does it all.. Then take a week off and go put some hours on it :-) Seriously, My horizon gyro was DOA and out of warranty from first flight on. Rather than replace it, I'm saving up for a Dynon and will chuck the horizon, VG, vacuum gauge, and vacuum pump. The compass stays g. BTW, who's got them for $1800? Dave 'MFD' Hyde 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Prop Pitch Question | Eugene Wendland | Home Built | 2 | April 25th 04 03:22 AM |
| Question | Charles S | Home Built | 4 | April 5th 04 09:10 PM |
| Aluminum instrument panel finish? | Richard Riley | Home Built | 31 | February 4th 04 02:09 AM |
| Poly Dope Question | Michael | Home Built | 3 | January 29th 04 07:10 AM |
| Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |
Hybrid Mode
