|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 18th 04, 10:10 PM
|
|||
|
|||
I have one. It works. It was reasonably simple to install in a David
Clark clone (Softcom). I only bought it because I needed to repair the headset anyway. Philippe wrote: Hello, ACS sold an afordable set for retrofit old headsets with ANR electronics. Does some one use this? Is it simple to fit in a David Clack H10-30? Same question for Pilot Avionics 10-40? Thanks -- John Kimmel 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WANTED! David Clark Headset | [email protected] | Aerobatics | 0 | December 29th 04 05:21 PM |
| Headset connections (attn: Jim Weir) | Bruce | Home Built | 5 | April 20th 04 03:56 PM |
| Headset with mobilephone connection | Mads | Home Built | 2 | January 8th 04 06:51 AM |
| HEADSET | Administrator | Home Built | 0 | October 27th 03 05:43 PM |
| Lynx Headset | Jimmy Galvin | Home Built | 1 | September 30th 03 12:23 AM |
Hybrid Mode
