![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Carbon track in the mag distributor?
-- Cy Galley - Chair, Emergency Aircraft Repair Safety Programs Editor - TC EAA Sport Pilot "nauga" wrote in message news ![]() Update: New harness installed today. Same problem, #3 doesn't fire on the right mag, whether it's on the top or bottom plug. Runs like a top on the left mag, top or bottom plug. I'm going to try to get a new mag ASAP, but Unison said they're usually all or nothing, that it's not likely the mag would miss a single cylinder. I've gotten plenty of local help, and everyone here thinks it's the mag but not a common failure, especially in one so new. If it's *not* the mag, we're all at a loss for ideas. So much for flying the time off and taking it to CA anytime soon. Any bright ideas? Dave 'sparky' Hyde |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fiberglass Cowl Problem | Boelkowj | Home Built | 6 | December 20th 03 02:08 PM |
Garmin 195 screen problem | BPattonsoa | Home Built | 30 | December 3rd 03 02:14 AM |
Hot Spark Ignition | Larry Smith | Home Built | 26 | November 19th 03 08:24 PM |
Electronic Ignition | Andre | Home Built | 1 | September 5th 03 06:15 PM |
2nd update on Review of Plasma II Ignition System | MikeremlaP | Home Built | 8 | July 22nd 03 01:37 AM |