|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
February 14th 05, 03:25 AM
|
|||
|
|||
Managed to locate the set that I had at home.
#6 Bulkhead nut is 75 inch-pounds +/- 5% for clean and dry threads. #4D nuts get 75 inch-pounds +/- 5% also Craig C. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Torque values for oil screen | John Clonts | Owning | 2 | January 25th 05 12:01 AM |
| Fuel pump fittings | Evan Carew | Home Built | 15 | October 3rd 04 03:13 AM |
Hybrid Mode
