|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
October 14th 04, 04:03 AM
|
|||
|
|||
On Thu, 14 Oct 2004 00:30:57 GMT, "Dick"
wrote: Not knowing all the details I'd say to: elongate existing holes in one part to fit the 3/8" bolts and use an oversized washer on the top (inside?) to help cover the larger hole, and spread the load better. HTH. z 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 05:03 AM |
| Question | Charles S | Home Built | 4 | April 5th 04 09:10 PM |
| Legal question - Pilot liability and possible involvement with a crime | John | Piloting | 5 | November 20th 03 09:40 PM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 01:26 AM |
| T Tail question | Paul Austin | Military Aviation | 7 | September 23rd 03 06:05 PM |
Threaded Mode