A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Soaring
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Winching - Cable danger.



 
 
Thread Tools Display Modes
  #1  
Old March 22nd 04, 06:34 PM
goneill
external usenet poster
 
Posts: n/a
Default

Our club is using cheap ordinary polyprop rope ,there is no tendency at all
to
spring at the winch even with releases under tension.
The rope contracts into its own length.
gary
"Shawn Curry" wrote in message
news:9zE7c.58429$JL2.758827@attbi_s03...
JS wrote:

Bill, excellent point!

I have always considered the winch drivers job to be more dangerous than


the

glider pilots. I tell people that each time I reach for the throttle, I
think about the 300 pounds of steel wire that is about to come straight

at
me doing 70 MPH.

Steel wire mesh or screen is totally inadequate to protect the driver.


The

winch cab windows should be 3/4" polycarbonate (Lexan) which, I'm told,


will

stop a 9mm bullet fired point blank. Yes, Lexan will get scratched
eventually but it's not that expensive to replace. The rest of the cab
should be at least .125 inch steel sheet.

Spectra will reduce the danger somewhat but the rest of the hardware

will
still be there and present the same dangers.

I would prefer a winch cab that is armored, weather tight and air
conditioned.

Bill Daniels



What about chanching the rotation direction of the cable reels, would it
make the lose cable end hitting the ground instead of drivers cabin?

js



Would Spectra or some other synthetic cable improve this? How much does
it stretch? My thought being that, there would still be a lot of energy
in a stretched light weight cable (imagine a 1000 foot rubber band
pointing at the driver) despite the lower weight and mass-to-drag while
falling.
Also, is the problem with steel wire/cable the elastic energy stored
from the launch, the mass of the falling steel, or a combination, that
creates the danger?

Shawn



 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Can anyone help, PLEASE - searching for zip-cord (aka: mono-cord, speaker wire, shooting wire, dbl hookup, rainbow cable, ribbon cable) Striker Cat Home Built 6 October 15th 04 08:51 PM
cable splicing(w/o ferrules) Andy Davey Soaring 2 March 19th 04 12:49 PM
rudder cable question Bob Loer Home Built 7 November 26th 03 08:34 AM
Rudder cable - was The Little Wheel in Back BD5ER Home Built 9 September 11th 03 04:14 PM
Winch cable Bill Daniels Soaring 5 August 24th 03 11:13 PM


All times are GMT +1. The time now is 07:25 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.