![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I have seen short sections of chain attached to each
side of the jack, so that when the jack is fully extended, both chains are drawn taunt. Make this happen at the correct height (glider main wheel just off the ground) JJ At 19:42 26 September 2004, wrote: Having a wobbling problem with the cradle on my KOMET Trailer while installing the wings on my glider. Any experience or suggestion to fixing this annoying problem? It causes excessive effort while installing the wings. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Trailer hitch inadvertant disconnect | Bill Daniels | Soaring | 5 | July 16th 04 03:17 AM |
Trailer spare - who woulda thunk? | Bill Daniels | Soaring | 7 | May 20th 04 04:47 PM |
Komet trailer strut | John Shelton | Soaring | 5 | November 15th 03 05:04 PM |
Tire Stiffness & trailer swaying - resolution | chris | Soaring | 6 | October 26th 03 03:50 PM |
Tire Stiffness & trailer swaying | chris | Soaring | 42 | October 22nd 03 03:51 AM |