|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
January 9th 05, 12:31 AM
|
|||
|
|||
Colibri wrote:
If the carbon vanes in a vacuum pump fail, any debris will be blown overboard. If the pump pressurizes the instruments, the debris will be blown into the instruments, ruining them. This is a good point, although hopefully a filter would protect against this expensive possibility. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wet vs Dry Vacuum Pump | Fastglasair | Home Built | 1 | December 15th 04 05:17 PM |
| Wet Vacuum Pumps | DBlumel | Home Built | 4 | August 19th 04 08:27 AM |
| Newbie Question - Vacuum vs Electric | Bill Denton | Aerobatics | 1 | April 15th 04 11:30 PM |
| Gyro Copter for Sale on EBAY | EC155 Pilot | Home Built | 0 | November 1st 03 11:34 PM |
| NACA duct ventrui | Chris W | Home Built | 7 | October 27th 03 04:11 PM |
Hybrid Mode
