|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
April 19th 05, 07:05 PM
|
|||
|
|||
GM wrote:
I guess it all comes down to the drum diameter. I have the sneaky suspicion that someone in the past bored them out way too big. If the drum has been machined over diameter, a brake specialist should be able to measure the drum and fit overthick linings on the shoes to match. (That may explain why you have "worn" shoes with plenty of wear lining left on them). Ian 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SZD-55 Wheel Brake Adjustment | WDM | Soaring | 2 | January 20th 11 09:25 AM |
| BRAKE FLUID | Ventus B | Soaring | 9 | October 17th 04 07:25 PM |
| Cobra Brake Parts or Axle | WDM | Soaring | 1 | October 11th 04 05:09 AM |
| Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 06:15 PM |
| Brake caliper flange | Stealth Pilot | Home Built | 5 | July 7th 03 04:19 PM |
Hybrid Mode
