|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 6th 05, 04:11 PM
|
|||
|
|||
On Thu, 05 May 2005 23:20:18 GMT, "Bruce A. Frank"
wrote: I have a print that, as best I can read it, calls for a fitting # AN 867-6. Is that a standard 3/8 tapered (NPT) thread fitting for welding on fuel tanks? Can anyone point me to a chart that has pictures of the AN fittings and possibly a translation to equiv. pipe or tube specifications? just to put the correct answer here in the replies. an867-6 is a 3/4inch female pipe thread in a weldable fitting which is 2 1/4 inches diameter by 13/16th of an inch high. aircraft spruce has them Stealth Pilot 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Proper Torque for Fuel Fittings | Steve Waltner | Home Built | 10 | February 20th 05 12:46 AM |
| Fuel pump fittings | Evan Carew | Home Built | 15 | October 3rd 04 03:13 AM |
| 37 degree fitting | Ernest Christley | Home Built | 8 | June 17th 04 03:29 AM |
| Need advice on Aeroquip fittings | Corky Scott | Home Built | 2 | December 12th 03 12:46 AM |
| Cobra trailer fittings for different glider makes & models | John W | Soaring | 4 | September 24th 03 03:21 PM |
Hybrid Mode
