|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
August 25th 05, 01:06 AM
|
|||
|
|||
add to this is check to make sure you valve cores are tight.
Michelle Jim Burns wrote: We find we need to add a little air every few weeks, infact, I need to do it tonight. Couple things to check. How old are your tubes? You may need new tubes. Tubes are usually natural rubber and will age and crack. Do you have steel stem caps that you can tighten with a wrench? The steel stem caps will have a rubber seal that seals against the rim of the valve stem. Just don't over torque and rip the base of the stem. Jim 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tires again (but this time on the tow vehicle) | Papa3 | Soaring | 37 | February 7th 05 02:30 PM |
| WTB: Good Set 500 x 5 Wheels, Tires and Brakes | Steve Sharp | Owning | 0 | March 20th 04 04:48 AM |
| WTB: Good Set 500 x 5 Wheels, Tires and Brakes | Steve Sharp | Restoration | 0 | March 20th 04 04:48 AM |
| Flat Spin | JJ Sinclair | Soaring | 34 | February 10th 04 05:57 PM |
| Tire Stiffness & trailer swaying - resolution | chris | Soaring | 6 | October 26th 03 03:50 PM |
Hybrid Mode
