![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
In article NwoZe.161520$084.66032@attbi_s22,
"Jay Honeck" wrote: When you finished, did you "properly" store the torque wrench? (Just a test to see if you read the instructions that came with the tool.) Um, well, I very carefully put it back in the cheap plastic case it came in, and wrapped the directions around the handle. Was there more to it? unlock it, and unload the setting (e.g., set the torque setting to the low end of the scale). -- Bob Noel no one likes an educated mule |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need Champion C26 Spark Plugs (era circa WW-II). | J. Graham | Owning | 1 | July 30th 05 05:57 PM |
Spark Plugs: Champion vs. Unison | Jonathan Goodish | Owning | 7 | May 6th 05 11:19 PM |
Unison spark plugs | Ed Sullivan | Home Built | 3 | April 21st 05 02:10 PM |
Color of spark plugs | john smith | Owning | 5 | March 2nd 04 03:08 AM |
Spark plugs for ASH26E | Ludovic Launer | Soaring | 4 | February 3rd 04 07:56 PM |