![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
|||
|
|||
|
"Peter" wrote in message ... "Mike Rapoport" wrote These two things combined with the fact that the prop has a high collection efficiency because of its thin cross section This I don't see - as it happens, the SOP for this turboprop when in icing conditions is to go max revs, the reason being that the less the AOA the less ice will be picked up. They also go 10-15-deg flaps for the same reason - it reduces the wing AOA. I donn't see the conflict between what I said and what you are saying. BTW does the flight manual say that the reason for going to higher rpm is to reduce AOA? Mike MU-2 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 11:18 PM |
| my ignorance | LCT Paintball | Home Built | 25 | April 9th 05 07:54 PM |
| Ivo Prop on O-320 | Dave S | Home Built | 14 | October 15th 04 04:04 AM |
| IVO props... comments.. | Dave S | Home Built | 16 | December 7th 03 12:43 AM |
| Metal Prop vs. Wood Prop | Larry Smith | Home Built | 21 | September 26th 03 08:45 PM |