|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 21st 06, 10:21 PM
posted to rec.aviation.owning,rec.aviation.piloting
|
|||
|
|||
Prop position
"Orval Fairbairn" wrote: I would not be too concerned about it. Remember -- the rings rotate in their lands and can sometimes end up with all the gaps lined up, thus changing the effective compression. This appears to be the case here, since the prop is now stopping in the usual place. But it's not; that's the problem. It stopped in the usual place 3 times at 3 different shutdowns Sunday, then stopped in the new place when I got home Sunday night. To add fat to the fi is it always the same blade on the same side, or do they swap? They swap. -- Dan C-172RG at BFM 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Prop position | Dan Luke | Piloting | 28 | March 22nd 06 06:46 PM |
| Air Force One Had to Intercept Some Inadvertent Flyers / How? | Rick Umali | Piloting | 29 | February 15th 06 04:40 AM |
| Nearly had my life terminated today | Michelle P | Piloting | 11 | September 3rd 05 02:37 AM |
| 3 blade prop position on 6cyl engine. | Paul Lee | Home Built | 3 | February 26th 04 12:47 AM |
| IVO props... comments.. | Dave S | Home Built | 16 | December 6th 03 11:43 PM |
Hybrid Mode
