![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Roger wrote:
I busted a leg ice skating. (broke the outer bone right off) Had to have it screwed back together. They never even asked to see the X-Ray. OTOH I had the cast off in 4 weeks for physical therapy, and was back ice skating in 60. I had a removable walking cast. Once the swelling had gone down I had no restrictions as to driving ... or what ever. WTH? If they plated and screwed it, what did you need a cast for? It's already held together by the hardware. I never did have a limp. (except with the cast on) Only thing is, if I fly commercial I have to carry a copy of the X-Ray as I still have the metal plate and screws in my leg. I don't see why. I carried two plates with 13 screws in my arm and 4 screws in my hip without ever setting off a metal detector *anywhere*. Now I'm minus one of the plates, 6 of the screws in my arm and the 4 screws in my hip but I've gained a prosthetic hip. Still haven't ever set off a metal detector. I figure that must be some sort of urban legend. I've heard of others setting them off but never talked to anyone who it happened to themselves. And I work on an orthopedics / neuro unit, so I talk to a *lot* of folks with hardware in them. They tell me I'll have to have it out some day, but it doesn't bother so I've figured, why bother. There is some evidence to suggest that long term existence of hardware may lead to osteoporosis but it is hardly definitive. Frankly, if it ain't broke, don't fix it. The only reason I got rid of some of my hardware was that it remained infected for all the years I had it and it started draining spontaneously every couple of weeks. I can't be dripping from my arm while working on a surgical floor so it had to be fixed... and it was. No more problems. The other remaining plate has been fine and I have no plans to remove it... don't even know it's there most of the time. My hip got arthritic and I have a new one now so I ditched the screws in the old one. All of my orthopedic procedures have been well documented with the FAA. I did not mention the EGD as it was just part of a workup for another procedure rather than because of a particular health problem. The subsequent surgery was disclosed though... -- Mortimer Schnerd, RN VE |
#2
|
|||
|
|||
![]() " Only thing is, if I fly commercial I have to carry a copy of the X-Ray as I still have the metal plate and screws in my leg. I don't see why. I carried two plates with 13 screws in my arm and 4 screws in my hip without ever setting off a metal detector *anywhere*. Right. I have 4 big screws and two rods in my back, and don't set off any metal detectors. Plates and screws and other surgical hardware is either titanium, or high grade stainless steel, both of which are non magnetic. You will not set off any metal detectors, I'll bet. Have you gone through any pre-flight screening, and set off the alarm? -- Jim in NC |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFI without commercial? | Jay Honeck | Piloting | 75 | December 8th 10 04:17 PM |
Student Pilot Who Gets 5 Months for Lying on His Application for Medical | [email protected] | Home Built | 2 | June 30th 05 03:00 AM |
Sport Pilot cuts off special issuance at the knees | Juan~--~Jimenez | Home Built | 40 | August 10th 04 01:19 PM |
Question Medical | Captain Wubba | Piloting | 5 | June 11th 04 05:12 AM |
Question on medical and kidney stones | nospam | Piloting | 13 | November 8th 03 07:10 AM |