![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() "GeorgeC" wrote in message ... Can you point me to a tutorial on "3D Solid State gyroscope". GeorgeC Short FOG info is at: http://www.nsd.es.northropgrumman.co...view/index.htm MEMS units: http://www.omniinstruments.co.uk/gyro/gyro.html Both are solid state units. FOG units will give lower drift, but are higher in price than the MEMS units. There are also other basic designs and most are tradeoffs between cost, environmental specs and performance. Google will give you many more hits. John Severyn @KLVK |
#2
|
|||
|
|||
![]()
Thanks, I did know why I didn't think of Google, I use for everything else.;-)
On Sat, 20 May 2006 14:37:08 -0700, "J. Severyn" wrote: "GeorgeC" wrote in message .. . Can you point me to a tutorial on "3D Solid State gyroscope". GeorgeC Short FOG info is at: http://www.nsd.es.northropgrumman.co...view/index.htm MEMS units: http://www.omniinstruments.co.uk/gyro/gyro.html Both are solid state units. FOG units will give lower drift, but are higher in price than the MEMS units. There are also other basic designs and most are tradeoffs between cost, environmental specs and performance. Google will give you many more hits. John Severyn @KLVK GeorgeC |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
egyro solid state gyro | DavidH | Home Built | 0 | October 31st 05 09:23 PM |
Backup AI (using solid state gyro) for portable | Andrew Gideon | Piloting | 14 | January 27th 05 08:41 AM |
Backup AI (using solid state gyro) for portable | Andrew Gideon | Products | 13 | January 27th 05 08:41 AM |
Solid State Gyro | PaulH | Owning | 2 | March 31st 04 03:41 PM |
Solid State Gyro;s on Ipaq | Ben Flewett | Soaring | 1 | October 13th 03 05:15 PM |