|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 7th 06, 10:00 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Welding question: reinforce by inner sleeve
Folks - 43-13-1B says an inner sleeve can be up to 1/16th inch smaller
in diameter than the ID of the original tubing. When you slip the inner tube inside the original tube 1/16th turns into a lot of slop. Do you make any attempt to center the inner tube in the original tubing? If so, how? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Welding question - | Michael Horowitz | Restoration | 11 | September 7th 06 04:52 PM |
| Aluminum welding | Ernest Christley | Home Built | 5 | April 24th 06 12:47 PM |
| Thorp T18 Plans question | Stealth Pilot | Home Built | 8 | January 7th 05 07:11 AM |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 06:03 AM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 02:26 AM |
Threaded Mode