![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Ok Kyle,
The first thing to do is to not panic and jump into a mechanical repair involving material removal, sanding, polishing. The first thing I would do is to get a bit of METHANLOL and see if the film is removable. Methanol doesn't hurt acrylic in the least. If that doesn't work, ues V&PM Naptha, Use soft cotton to clean it, I use flannel from Walmart. My experience is that the stuff is usually on the INSIDE of the bubble and are products fron the sublimation of the plastics in the interior of the airplane. DEFINATELY solvent wipe stuff before you get out the polishing compounds. Another thing that few bother with is to use a canopy cover to keep dust off the canopy. Most dust is pretty acidic, remember acid rain and car paint jobs. Get a big soft piece of flannel at Walmart and keep it on the plane when you arent flying it. Plexiglass generates static electric charges and pulls dust out of the air when it sits. Oh Yeah, I make canopies and acrylic stuff for a day job, so you can take this for what it is worth -- Have a great day Scott "Kyle Boatright" wrote in message news ![]() I've noticed that the windscreen and canopy on my RV-6 has developed a haze on its exterior. The history of the canopy is that the canopy was manufactured about 7 years ago, with the airplane first flying about 5 years ago. The airplane has always been hangared (other than the occasional overnight stay somewhere), and has been treated properly during its life. My cleaner of choice is Plexus, which Aircraft Spruce and several other outlets sell for aircraft canopies. The only things I can imagine that could have caused the haze on the canopy is either the plexus, exposure to corvis oil (the smoky stuff) at airshows, or some sort of airborne contaminant in my hangar (e.g. a neighbor spray painting). For what it is worth, the canopy doesn't have any scratches, so I probably don't need an aggressive abraisive cleaner. The bottom line is that I'm interested in removing this haze layer. Any recommendations? Thanks, KB |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Haze domes | Roger Kelly | Soaring | 8 | June 26th 05 04:29 PM |
OOPS! Got contact cement on the windshield | Mike Rapoport | Owning | 12 | November 13th 04 11:13 PM |
Windshield Antenna Kits | Scrabo | Piloting | 2 | July 12th 04 04:58 PM |
windshield wipers | tony roberts | Owning | 8 | June 1st 04 02:45 AM |
Arrgh! I may have scratched my windshield! | Peter R. | Owning | 7 | April 28th 04 07:58 AM |