|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
August 27th 03, 01:01 AM
|
|||
|
|||
in assemblies they appear to be bright enough... see:
http://www.killacycle.com/Lights.htm Or cert'd units from Whelen: http://www.dallasavionics.com/whelen/ Cheers, Pete Europa Builder "Ron Natalie" wrote in message m... "pekka1510" wrote in message Does semiconductor LEDs work near with strobe flashtubes (HIGH VOLTAGE)??? I am looking ElectroMagneticCompatibility. Anyone experiences or recommendations, please? Can't answer the question about interoperability with flashtubes, but these are starting to show up for marine use, however there's nowhere near bright enough (at least the marine ones) to meet the Part 23 brightness requirement for position lights. You need up to 40 candela over 110 degrees horizontal and +/- 90 degrees vertical. Can be done I guess, but can't find anything canned that has that kind of specs. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LEDs | Morgans | Home Built | 6 | August 19th 03 03:49 AM |
| LED for position lights | Jerry Springer | Home Built | 2 | August 19th 03 01:43 AM |
Hybrid Mode
