|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
September 14th 06, 08:37 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
RT-359A transponder question
"Lars" wrote in message ps.com... Wonder why they donīt recommend using the switched output? Itīs only a 60mA current draw, but maybe it is the 420mA warm up current that is the problem... /Lars Probably to make sure that the circuitry has warmed up and stabilised enough by the time you switch on your transponder. I have not checked the ACK A-30 specs but it usually takes a few seconds after power-up for the circuit to give accurate readings. Rob 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transponder requirement confusion | [email protected] | Owning | 24 | August 17th 06 05:16 PM |
| My "stupid" transponder question now... | Chris G. | Piloting | 25 | September 20th 05 05:13 PM |
| Another stupid transponder question | Jay Honeck | Piloting | 21 | September 17th 05 03:50 AM |
| Stupid transponder question, or, stumped by the wife | John Kirksey | Piloting | 35 | September 15th 05 03:44 PM |
| transponder check? | Russell Duffy | Home Built | 10 | August 15th 03 12:36 AM |
Threaded Mode