|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 26th 06, 06:13 PM
posted to rec.aviation.owning
|
|||
|
|||
3-blade prop?
The Hartzell constant speed prop on my Husky blew a grease seal and
grease covered my front wind so completely I had to look out the side to land. It was a bit scary. The prop didn't need a complete rebuild but needed to have the seals re-done. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advancement of prop blade in flight, new information | Corky Scott | Piloting | 35 | August 28th 04 02:00 PM |
| Survey - 3 blade prop conversion- Cockpit vibration, happy or not | Fly | Owning | 20 | June 30th 04 05:32 PM |
| Hartzelll 3 blade prop | Matt Whiting | Owning | 6 | June 15th 04 01:29 AM |
| 3 blade prop position on 6cyl engine. | Paul Lee | Home Built | 3 | February 26th 04 12:47 AM |
| IVO props... comments.. | Dave S | Home Built | 16 | December 6th 03 11:43 PM |
Hybrid Mode
